MIPS Programming Homework - Updating Locations After Instructions?

For my Assembly Language course, I have been asked to fill out a table for the Assembly code in Figure 1 MIPS Assemb...

MIPS critical path of a branch instruction?

Suppose I have a MIPS processor performing a beq instruction e.g. beq $t1, $t2, label I'm trying to figure out th...

MIPS Branch Datapath?

I am programming a single cycle MIPS CPU and I am confused how the branch address is computed. Given this MIPS datap...

What does func means in R-Format instruction set??

I am very new to Assembly language. I was reading about MIPS architecture and I am stuck with the last field of the ...

MIPS assembly language - temporary register vs saved registers?

So far I have been using registers $s0-$s9 and same way as registers $t0-$t9. I have been told and read countless fo...

MIPS Instruction J-Format?

I have a question on the following MIPS code: If the first instruction is placed in memory address at 0xFFFFFF00, wh...

MIPS - Storing ints In Array From User Input?

I'm trying to store user input into an array, but when I use sw I get an error "store address not aligned on word bo...

How does the MIPS Logical OR Instruction work??

Assuming that $z0 is a register which always contains the number zero. Then the MIPS instruction OR $t0, $t1, $t2 p...

MIPS program jr $ra instructions and stack handling?

I am new to MIPS programming and have been struggling to understand MIPS program and how does it flow. Can anyone pl...

what does .space do in mips??

I got this problem for an assignment in which we have put these number in an array and add them without using a loop...

Comments in MIPS accurate??

Are my comments for this MIPS program accurately explaining what each statement line is doing? .data str1: .asciiz ...

MIPS: lw (load word) instruction?

Is lw $s0,8($0) the same as lw $s0,0($v0)? I do not see the difference. I think the 8 represents the offset, which ...

Reading and printing an integer in mips?

My program is suppose to read an integer and print it back to the user but every time it just prints 268501230 no ma...

why does'nt MIPS have a Store Immediate instruction just like Load Immediate instruction?

MIPS has a Load Immediate(LI) pseudo instruction to load a 32-bit immediate value into a register. But it does not h...